Insignia NS-PRCL01 Quick Setup Guide (English) - Page 2

Step 4 Using your radio Setting the time 1 Press and hold TIME SET until the hour blinks on the display. 2 Press TIME+ or TIME- to set the hour. 3 Press TIME SET. The minutes blink on the display. 4 Press TIME+ or TIME- to set the minutes. 5 Press TIME SET to store the setting. Setting the alarm 1 Press and hold ALARM 1 (or ALARM 2 depending on the alarm you are setting) until the hour blinks on the display. 2 Press TIME+ or TIME- to set the hour. 3 Press ALARM 1 (or ALARM 2 depending on the alarm you are setting). The minutes blink on the display. 4 Press TIME+ or TIME- to set the minutes. 5 Press ALARM 1 (or ALARM 2) to store the setting. 6 Press ALARM 1 (or ALARM 2) repeatedly to set the alarm mode. Settings include: • Wake to buzzer- appears below the alarm icon. • Wake to radio- appears below the alarm icon. • Alarm off-Alarm icon disappears. Turning off the alarm • Press any button other than SNOOZE/DIMMER to turn off the alarm while the alarm is sounding. The alarm will be set for the same time the following day. If you do not want to set the alarm for the next day, press ALARM 1 or ALARM 2 repeatedly until the alarm icon disappears from the display. Using snooze • While the alarm is sounding, press SNOOZE/DIMMER. The alarm turns back on automatically nine minutes later. • To cancel snooze (the alarm will not turn back on), press any button other than SNOOZE/DIMMER. The alarm will be set for the same time the following day. Setting and using station presets 1 Press RADIO ON/OFF to turn on your clock radio. 2 Press AM/FM to select the radio band you want to listen to. 3 Press TUNING+ or TUNING- to tune the radio up or down and select the station you want. 4 To save the station as a preset, press PRESET MEMORY. "MEM" and "01" blink on the display. 5 Press PRESET+ or PRESET- to select the preset number you want to assign to that station. 6 Press PRESET MEMORY again to confirm the setting. The station is stored in memory. 7 Repeat Steps 3 through Step 6 to store as many as ten AM presets and ten FM presets. 8 To select a preset station, briefly press PRESET+ or PRESET- repeatedly until you reach the station you want. "MEM" appears on the display, along with the preset number selected and the station frequency. Projecting the time 1 Switch off the room lights to darken the room. 2 Press PROJECT to turn the projector on. 3 Turn the projector unit slowly to aim the projected image on the wall or ceiling. 4 If the image appears to be upside down on your wall, or upside down on the ceiling when you are lying in bed, press ROTATE to rotate the projected image. 5 If the image appears fuzzy and out of focus, slowly rotate the focus adjustment ring clockwise or counter-clockwise until you obtain the sharpest image. 6 To turn the projector off, press PROJECT. Troubleshooting Problem Solution The display is off Make sure that the AC-DC adapter is connected to radio and the AC-DC adapter is plugged into a power outlet. No sound Increase the volume and make sure that the radio is on and tuned to a radio station. The sound has interference Make sure that the radio is not too close to a TV or other appliance. The LCD display is too dim Adjust the backlight. Radio reception is weak The AM bar antenna is inside the cabinet. If AM reception is weak, change the position of cabinet until the internal antenna picks up the strongest signal. The FM antenna is at the back of the cabinet. If FM reception is weak try varying the position and direction of the FM antenna until you find the strongest signal. Specifications Power supply DC IN 6V/0.5A FM band 87.5 - 107.9 MHz in 200 KHz steps (USA) AM band 530 - 1710 KHz in 10 KHz steps (USA) Output power 1 W Speaker 2.25" x 1 Operating temp. (Max) 14° ~ 104°F (-10° ~ 40°C) 90-day limited warranty Visit www.insigniaproducts.com for details. Playing the radio 1 Press RADIO ON/OFF to turn on your clock radio. • To select the radio band you want to listen to, press AM/FM. • To tune the radio up or down and select the station you want, press TUNING+ or TUNING-. • To auto search for stations, press and hold TUNING+ or TUNING- for more than two seconds. • To adjust the volume, press VOLUME+ or VOLUME-. • To tune to the next preset station, press PRESET+ or to tune to the previous preset station, press PRESET-. 2 Press RADIO ON/OFF to turn off your clock radio. FCC Part 15 This device complies with Part 15 of the FCC Rules. Operation of this product is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. © 2009 Best Buy Enterprise Services, Inc. All rights reserved. INSIGNIA is a trademark of Best Buy Enterprise Services, Inc. Registered in some countries. All other products and brand names are trademarks of their respective owners. ENGLISH 09-0796