Insignia NS-RFD26XSS0 User Guide - Page 10

Finding a suitable location CAUTION: Your refrigerator is heavy. When moving your refrigerator for cleaning or service, cover the floor with cardboard or a hard board to avoid floor damage. Always pull your refrigerator straight out when moving it. Do not wiggle or "walk" your refrigerator when trying to move it, as floor damage could occur. WARNING: Explosion and Fire Hazard Keep flammable materials and vapors, such as gasoline, away from your refrigerator. Failure to do so can result in death, explosion, or fire. • Place your refrigerator on a floor that is strong enough to support your refrigerator when it is fully loaded. • Do not install your refrigerator on carpeting or a rug. • Your refrigerator is designed to be free standing and should not be recessed or built-in. • Your refrigerator is designed for indoor, household use only. If you use your refrigerator in a garage, make sure that the ambient temperature is between 55° F (13° C) and 110° F (43° C). If you operate your refrigerator outside this temperature range, your refrigerator may not work correctly. The preferred room temperature range for optimum performance, which reduces electricity usage and provides superior cooling, is between 60° F (15° C) and 90° F (32° C). We recommend that you do not install your refrigerator near a heat source, such as an oven or radiator. • Before moving, retract the leveling legs to avoid scraping the floor, then adjust the feet to keep your refrigerator level. • If you locate your refrigerator next to a fixed wall, allow sufficient space on the sides for the doors to swing open. • Your refrigerator has rollers, which should be used for only forward and backward movement. Moving your refrigerator sideways may damage your floor. • Position your refrigerator away from direct sunlight and sources of heat, such as a stove, heater, or radiator. Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extremely cold temperatures may also prevent your refrigerator from performing correctly. • Avoid locating your refrigerator in moist areas. Locating near a water supply A cold water supply with water pressure between 30 and 125 psi (207 and 862 kPa) is required to operate the ice maker. If your refrigerator is installed in an area with low water pressure (below 30 psi (207 kPa)), you can install a booster pump to compensate for the low pressure. Under normal conditions, a 200 cc (5.75 oz.) cup can be filled in about 10 seconds. If the water pressure is less than what is required, ice cubes could be hollow or irregularly shaped. If you have questions about your water pressure, call a licensed, qualified plumber. WARNING: Fire or Explosion Hazard Do not puncture the refrigerant tubing. Follow handling instructions carefully. Your refrigerator uses flammable refrigerant. Failure to do so can result in death, explosion, or fire. CAUTIONS: • A qualified plumber should make the water connection. • Using water pressure that is outside the 30 to 125 psi (207 to 862 kPa) range can cause serious malfunction and severe, damaging water leaks. If you're using a reverse osmosis water supply: IMPORTANT: The pressure of the water supply coming out of a reverse osmosis system going to the water inlet valve of your refrigerator needs to be between 30 and 125 psi (207 and 862 kPa). If water pressure is too low: • Check to see whether the sediment filter in the reverse osmosis system is blocked. Replace the filter if necessary. • Allow the storage tank on the reverse osmosis system to refill after heavy use. The tank capacity could be too small to keep up with the requirements of your refrigerator. If you have questions about your water pressure, call a licensed, qualified plumber. 10 www.insigniaproducts.com