Insignia NS-RTM10WH7 User Manual - Page 19

Troubleshooting

Page 19 highlights

9.9 and 11.5 cu. ft. Top Mount Refrigerator Troubleshooting Caution Do not try to repair your refrigerator yourself. Doing so invalidates the warranty. Error codes LED display LED 1 and LED 2 lit LED 1 and LED 3 lit LED 1 and LED 4 lit Problem Temperature sensor circuit Freezer defrost sensor Ambient temperature sensor Problem Possible cause Possible solution The refrigerator does not The refrigerator is unplugged. Make sure that the refrigerator is plugged in and that the plug operate. is pushed completely into the outlet. The fuse on the circuit is blown Check the house fuse/circuit breaker box and replace the fuse or the circuit breaker is tripped. or reset the circuit breaker. Power failure. If a power failure occurs, the refrigerator turns off. Wait until the power is restored. The compressor turns on The door has been opened too Make sure that the door is closed properly. Clean the door seal and off frequently. often or was not closed properly. if necessary. The door seal may be dirty. The room temperature is hotter This is normal, under the circumstances. than normal. A large amount of food was recently added to the refrigerator. This is normal, under the circumstances. The thermostat is not set correctly. Reset the thermostat correctly. The refrigerator does not have The refrigerator should be no closer than five inches from the the correct clearances. adjacent walls. The refrigerator has recently Allow four hours for the refrigerator to cool down completely. been disconnected for a period of time. Food in the refrigerator The thermostat is set too cold. Set the thermostat to a warmer setting. compartment is freezing. www.insigniaproducts.com 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

19
9.9 and 11.5 cu. ft. Top Mount Refrigerator
www.insigniaproducts.com
Troubleshooting
Error codes
Caution
Do not try to repair your refrigerator yourself. Doing so
invalidates the warranty.
LED display
Problem
LED 1 and LED 2 lit
Temperature sensor circuit
LED 1 and LED 3 lit
Freezer defrost sensor
LED 1 and LED 4 lit
Ambient temperature sensor
Problem
Possible cause
Possible solution
The refrigerator does not
operate.
The refrigerator is unplugged.
Make sure that the refrigerator is plugged in and that the plug
is pushed completely into the outlet.
The fuse on the circuit is blown
or the circuit breaker is tripped.
Check the house fuse/circuit breaker box and replace the fuse
or reset the circuit breaker.
Power failure.
If a power failure occurs, the refrigerator turns off. Wait until
the power is restored.
The compressor turns on
and off frequently.
The door has been opened too
often or was not closed properly.
The door seal may be dirty.
Make sure that the door is closed properly. Clean the door seal
if necessary.
The room temperature is hotter
than normal.
This is normal, under the circumstances.
A large amount of food was
recently added to the
refrigerator.
This is normal, under the circumstances.
The thermostat is not set
correctly.
Reset the thermostat correctly.
The refrigerator does not have
the correct clearances.
The refrigerator should be no closer than five inches from the
adjacent walls.
The refrigerator has recently
been disconnected for a period
of time.
Allow four hours for the refrigerator to cool down completely.
Food in the refrigerator
compartment is freezing.
The thermostat is set too cold.
Set the thermostat to a warmer setting.