Insignia NS-WC29SS3 User Guide - Page 16
Troubleshooting, Error codes
View all Insignia NS-WC29SS3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Troubleshooting Error codes If a fault is detected, the display shows one of the following codes: • E1: Temperature sensor fault • E6: Communication fault If any of these error codes appears on the display, contact your local dealer or service center. Do not try to repair your cooler yourself. PROBLEM POSSIBLE CAUSE SOLUTION My cooler does Your beverage cooler Make sure that your cooler is plugged in not operate. is unplugged. and that the plug is pushed completely into the outlet. The fuse on the circuit Check the house fuse or circuit breaker box is blown or the circuit and replace the fuse or reset the circuit breaker is tripped. breaker. Power failure. If a power failure occurs, your cooler turns off. Wait until the power is restored, then turn it on again. The plug does not fit Make sure that your power source has the the outlet. correct voltage. The cooler door does not close completely. The shelf is out of position. The door gaskets are dirty. Adjust the shelf correctly. Clean the door gaskets. The cooler is not level. Level your cooler with the leveling feet. The gasket has If the door gasket does not seal, try heating deformed or does not then cooling the seal. You can use an fit the shape of the electric hair dryer to heat the seal. door. My cooler is not cold enough. The door has been opened too often or was not closed correctly. Make sure that the door is closed correctly. You have just added a Allow time for new beverages to cool, then large number of check again. warm beverages to your cooler. The temperature control is set too warm. Set the control to a colder setting. Your wine cooler does Your wine cooler may not have enough not have enough clearance from walls or the ceiling. See ventilation. Providing ventilation on page 8. 16 www.insigniaproducts.com