Intel BLKD201GLY2 Product Specification - Page 24
Audio Subsystem
UPC - 735858197724
View all Intel BLKD201GLY2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Intel Desktop Board D201GLY2 Technical Product Specification 1.7.1 Serial Port The serial port A connector is located on the back panel. The serial port supports data transfers at speeds up to 115.2 kbits/sec with BIOS support. For information about The location of the serial port A connector Refer to Figure 7, page 37 1.7.2 Parallel Port The 25-pin D-Sub parallel port connector is located on the back panel. Use the BIOS Setup program to set the parallel port mode. For information about The location of the parallel port connector Refer to Figure 7, page 37 1.7.3 Keyboard and Mouse Interface PS/2 keyboard and mouse connectors are located on the back panel. NOTE The keyboard is supported in the bottom PS/2 connector and the mouse is supported in the top PS/2 connector. Power to the computer should be turned off before a keyboard or mouse is connected or disconnected. For information about The location of the keyboard and mouse connectors Refer to Figure 7, page 37 1.8 Audio Subsystem The audio subsystem consists of the following devices: • SiS964 Southbridge • ADI AD1888 audio codec The audio subsystem includes these features: • Signal-to-noise ratio ≥ 90 dB • Supports wake events (driver dependent) • Mic in pre-amp that supports dynamic, condenser, and electret microphones The audio subsystem supports the following audio interfaces: • Front panel audio header, including pins for: ⎯ Line out ⎯ Mic in 24