Intel BLKD865GLC Product Specification - Page 133
Error Messages and Beep Codes
View all Intel BLKD865GLC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
5 Error Messages and Beep Codes What This Chapter Contains 5.1 BIOS Error Messages 133 5.2 Port 80h POST Codes 135 5.3 Bus Initialization Checkpoints 139 5.4 Speaker ...140 5.5 BIOS Beep Codes ...140 5.1 BIOS Error Messages Table 79 lists the error messages and provides a brief description of each. Table 79. BIOS Error Messages Error Message GA20 Error Pri Master HDD Error Pri Slave HDD Error Sec Master HDD Error Sec Slave HDD Error Pri Master Drive - ATAPI Incompatible Pri Slave Drive - ATAPI Incompatible Sec Master Drive - ATAPI Incompatible Sec Slave Drive - ATAPI Incompatible A: Drive Error Cache Memory Bad CMOS Battery Low CMOS Display Type Wrong CMOS Checksum Bad CMOS Settings Wrong CMOS Date/Time Not Set DMA Error FDC Failure HDC Failure Explanation An error occurred with Gate A20 when switching to protected mode during the memory test. Could not read sector from corresponding drive. Corresponding drive in not an ATAPI device. Run Setup to make sure device is selected correctly. No response from diskette drive. An error occurred when testing L2 cache. Cache memory may be bad. The battery may be losing power. Replace the battery soon. The display type is different than what has been stored in CMOS. Check Setup to make sure type is correct. The CMOS checksum is incorrect. CMOS memory may have been corrupted. Run Setup to reset values. CMOS values are not the same as the last boot. These values have either been corrupted or the battery has failed. The time and/or date values stored in CMOS are invalid. Run Setup to set correct values. Error during read/write test of DMA controller. Error occurred trying to access diskette drive controller. Error occurred trying to access hard disk controller. continued 133