Intel D845GEBV2 Product Guide - Page 29
Connecting the IDE Cable
View all Intel D845GEBV2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Installing and Replacing Desktop Board Components Connecting the IDE Cable The Intel® boxed desktop board package includes two IDE cables. Either cable can connect two drives to the desktop board. The cables support the Ultra DMA-33 and ATA-66/100 transfer protocols. Figure 10 shows the correct installation of the cable. ✏ NOTE ATA-66/100 compatible cables are backward compatible with drives using slower IDE transfer protocols. If an ATA-66/100 disk drive and a disk drive using any other IDE transfer protocol are attached to the same cable, the maximum transfer rate between the drives may be reduced to that of the slowest drive. ✏ NOTE Do not connect an ATA device as a slave on the same IDE cable as an ATAPI master device. For example, do not connect an ATA hard drive as a slave to an ATAPI CD-ROM drive. For correct function of the cable: 1. Observe the precautions in "Before You Begin" on page 21. 2. Attach the cable end with the single connector to the Intel desktop board. 3. Attach the cable end with the two closely spaced connectors to the drives. B OM13608 Figure 10. Connecting the IDE Cable 29 A