Intel D845GERG2 Product Guide - Page 12
Main Memory, Intel® 845GE Chipset - specs
UPC - 735858157803
View all Intel D845GERG2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Intel Desktop Board D845GERG2/D845GEBV2 Product Guide Main Memory ✏ NOTE To be fully compliant with all applicable Intel® SDRAM memory specifications, the board should be populated with DIMMs that support the Serial Presence Detect (SPD) data structure. If your memory modules do not support SPD, you will see a notification to this effect on the screen at power up. The BIOS will attempt to configure the memory controller for normal operation. The desktop board supports system memory as defined below: • Up to two 184-pin Double Data Rate (DDR) SDRAM Dual Inline Memory Modules (DIMMs) with gold-plated contacts. Supported memory configuration are: - DDR333: to run DDR333 memory at full speed requires an Intel Pentium 4 processor with 533 MHz front side bus frequency (FSB). DDR333 memory will run only at DDR266 speeds when using a processor with 400 MHz FSB. - DDR266: requires an Intel Pentium 4 processor with 533/400 MHz FSB, or Intel Celeron processor with 400 MHz FSB. • Unbuffered and non-registered single or double-sided DIMMs • Serial Presence Detect (SPD) memory only • Non-ECC RAM (ECC memory will run in non-ECC mode) • 2.5 V memory ✏ NOTE Desktop Board D845GERG2/D845GEBV2 has been designed to support DIMMs based on 512 Mbit technology up to 2 GB, but this technology has not been validated on these Intel desktop boards. For more information about the latest list of tested memory, refer to the Intel World Wide Web site at: http://support.intel.com/support/motherboards/desktop/ All memory components and DIMMs used with the desktop boards must comply with the PC SDRAM specifications. You can access these documents through the World Wide Web at: http://www.intel.com/technology/memory/pcsdram/spec/ For information about installing memory, see Chapter 2 starting on page 21. Intel® 845GE Chipset The Intel 845GE chipset consists of the following devices: • Intel 82845GE Graphics and Memory Controller Hub (GMCH) with AHA bus • Intel 82801DB I/O Controller Hub (ICH4) with AHA bus • Firmware Hub (FWH) 12