Intel DH61BF Integration Guide - Page 3

3 Install a Processor For a list of processors this board supports, go to: http://processormatch.intel.com. LGA1155 Processor Socket B. Open the Load Plate Rotate the socket lever to lift the load plate away from the socket. A• When opening the socket, DO NOT TOUCH the gold socket contacts. • IN 7 • A. Unlatch the Socket Lever Push the lever down and away from the socket to release it. Load Plate D Make sure the load plate is in the fully open position. • // A• When unpacking a processor, hold by the edges only to avoid touching the gold contacts. Lever C. Install the Processor A• The processor must align correctly with the socket before installation. DO NOT DROP the processor into the socket. Hold the processor with your thumb and index finger as shown to align your fingers with the socket cutouts. Make sure that the processor Pin 1 indicator (gold triangle) is aligned with the Pin 1 chamfer on the socket. @ Make sure that the notches on the processor align with the posts on the socket. 0 Lower the processor straight down without tilting or sliding it in the socket. Socket Cutout D. Close the Load Plate and Secure the Socket Lever e Carefully lower the load plate and make sure it slides under the shoulder screw cap as the lever is lowered. Continue to lower the lever and the socket cover will pop off. Latch the socket lever under the load plate tab. Pick up the socket cover and remove it from the board. Shoulder Screw Cap NOTE: Save the socket cover and replace it if the processor is removed. Socket Cover -\ .-., :.-- 7 Pin 1 - "ti..',;••-7 Socket Cutout ig 3 -1W Load Plate Tab