Intel NUC5i3RYK User Guide - Page 5

Intel NUC Kit D54250WYKH & D34010WYKH User Guide 3. Align the small notch at the bottom edge of the SO-DIMM with the key in the socket. 4. Insert the bottom edge of the SO-DIMM into the socket. 5. When the SO-DIMM is inserted, push down on the outer edge of the SO-DIMM until the retaining clips snap into place. Make sure the clips are firmly in place. Removing SO-DIMMs To remove a SO-DIMM, follow these steps: 1. Observe the precautions in "Before You Begin" on page 2. 2. Turn off all peripheral devices connected to the computer. Turn off the computer. 3. Remove the AC power cord from the computer. 4. Remove the computer's cover. 5. Gently spread the retaining clips at each end of the SO-DIMM socket. The SO-DIMM pops out of the socket. 6. Hold the SO-DIMM by the edges, lift it away from the socket, and store it in an anti-static package. 7. Reinstall and reconnect any parts you removed or disconnected to reach the SO-DIMM sockets. 8. Replace the computer's cover and reconnect the AC power cord. Installing a Mini-PCIe Wireless Adapter Only the following wireless adapters have been evaluated for regulatory compliance for use with the Intel NUC Kits D54250WYKH and D34010WYKH in all regions:  Intel® Centrino® Advanced-N 6235  Intel® Centrino® Advanced-N 6205  Intel® Centrino® Wireless-N 2230  Intel® Centrino® Wireless-N 2200  Intel® Dual Band Wireless-AC 7260 + Bluetooth*  Intel® Dual Band Wireless-N 7260 + Bluetooth  Intel® Dual Band Wireless-N 7260  Intel® Wireless-N 7260 + Bluetooth The operation of any other wireless adapter with Intel® NUC Kits D54250WYKH and D34010WYKH, other than those listed above, may violate regulatory compliance requirements for your region. For more information on wireless adapters, go to: http://www.intel.com/support/wireless/wlan. CAUTION When installing a Mini-PCIe wireless adapter on the Intel NUC, ensure that the adapter is fully seated in the connector before you power on the system. If the adapter is not fully seated in the connector, an electrical short may result across the connector pins. Depending on the over-current protection of the power supply, certain Intel NUC components and/or traces may be damaged. 5