Intel P4000IP Service Guide - Page 68
Removing and Installing the Hot-swap HDD EMI Shiled
View all Intel P4000IP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Hardware Installations and Upgrades 7. Install the front bezel. For instructions, see "Installing the Front Bezel (Pedestal Only)". 8. Install the air duct if the air duct is removed. For instructions, see the Quick Start User's Guide or Service Guide provided with your Intel server/workstation board. 9. Install the chassis cover. For instructions, see "Installing the Chassis Cover". 10. Plug all peripheral devices and the AC power cable into the server. 11. Power up the server. Removing and Installing the Hot-swap HDD EMI Shiled / NOTE This procedure applies only to the Intel® Server System P4000IP family with 8x2.5" hot-swap hard disk drive cage configuration. Removing the Hot-swap HDD EMI Shiled 1. Observe the safety and ESD precautions at the beginning of this book. 2. Power down the server and unplug all peripheral devices and the AC power cable. 3. Remove the chassis cover. For instructions, see "Removing the Chassis Cover". 4. Remove the front bezel. For instructions, see "Removing the front bezel (Pedestal Only)". 5. Remove the 8x2.5" Hot-swap HDD cage. For instructions, see "Removing 8x2.5" Hot-swap Hard Disk Drive Cage with Backplane" 6. Lift the EMI shield (see letter "A") and move EMI shield outward from the chassis (see letter "B"). Figure 63. Removing the Hot-swap HDD EMI Shield 50 Intel® Server System P4000IP and Intel® Workstation System P4000CR Service Guide