Intel P4000IP Service Guide - Page 75

Hardware Installations and Upgrades 9. Install the front bezel. For instructions, see "Installing the Front Bezel (Pedestal Only)". 10. Install the air duct if the air duct is removed. For instructions, see the Quick Start User's Guide or Service Guide provided with your Intel server/workstation board. 11. Install the chassis cover. For instructions, see "Installing the Chassis Cover". 12. Plug all peripheral devices and the AC power cable into the server. 13. Power up the server. Removing and Installing 8x2.5" Hot-swap Backplane Removing 8x2.5" Hot-swap Backplane 1. Observe the safety and ESD precautions at the beginning of this book. 2. Power down the server and unplug all peripheral devices and the AC power cable. 3. Remove the chassis cover. For instructions, see "Removing the Chassis Cover". 4. Remove the front bezel if it is installed. For instructions, see "Removing the Front Bezel (Pedestal Only)". 5. Remove the 8x2.5" Hot-swap Hard drives cage. For instructions, see "Removing 8x2.5" Hot-swap Hard Drive Cage Assembly". 6. Remove the screw on the backplane (see letter "A"). 7. Push the backplane (see letter "B") and remove the backplane from the cage (see letter "C"). Figure 71. Removing 8x2.5" Hot-swap Backplane Intel® Server System P4000IP and Intel® Workstation System P4000CR Service Guide 57