Intel P4000L Service Guide - Page 72
Removing and Installing Third, swap Hard, Disk Drive Cage Assembly
View all Intel P4000L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Hardware Installations and Upgrades 7. Install the front bezel. For instructions, see "Installing the Front Bezel (Pedestal Only)". 8. Install the air duct if the air duct is removed. For instructions, see the Quick Start User's Guide or Service Guide provided with your Intel server/workstation board. 9. Install the chassis cover. For instructions, see "Installing the Chassis Cover". 10. Plug all peripheral devices and the AC power cable into the server. 11. Power up the server. Removing and Installing Third 8x2.5" Hot-swap Hard Disk Drive Cage Assembly / NOTE This procedure applies only to the Intel® Server System P4000IP family with 8x2.5" hot-swap hard disk drive cage configuration. Removing Third 8x2.5" Hot-swap Hard Disk Drive Cage Assembly 1. Observe the safety and ESD precautions at the beginning of this book. 2. Power down the server and unplug all peripheral devices and the AC power cable. 3. Remove the chassis cover. For instructions, see "Removing the Chassis Cover". 4. Remove the front bezel if it is installed. For instructions, see "Removing the Front Bezel (Pedesal Only)". 5. Disconnect the power and data cables to the backplane. 6. Use screwdriver to release the hot-swap hard drive cage (see letter "C") from the chassis and remove the hot-swap hard drive cage (see letter "D"). 54 Intel® Server System P4000IP and Intel® Workstation System P4000CR Service Guide