Intel SC5400 Product Specification - Page 73
Intel® Server Chassis SC5400 4HDD and 6HDD Active SAS/SATA, Hot Swap Back Plane HSBP Overview - axx4drv3g
View all Intel SC5400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Intel® Server Chassis SC5400 5U Kit TPS Hot Swap Hard Disk Drive Bays 6.1.15 SAS/SATA Hot Swap Drive Cage Upgrade Kit The 4HDD and 6HDD SAS/SATA drive cage upgrade kit allows for installation of up to 10 hot swap SAS/SATA drives in the server. The kit includes a SAS/SATA hot-swap drive bay with mounting hardware. With this kit, the SAS/SATA hot swap drive cage can be connected to the SAS/SATA connectors on the server board or to a SAS/SATA RAID card, through the mated cable. The RAID level that is supported depends on the feature set of the SAS or SATA controller. The kit order codes are as follows: AXX4DRV3G AXX6DRV3G 6.2 Intel® Server Chassis SC5400 4HDD and 6HDD Active SAS/SATA Hot Swap Back Plane (HSBP) Overview The Intel® Server Chassis SC5400 4HDD or 6HDD Active SAS/SATA Hot Swap Backplane (HSBP) is a monolithic printed circuit board. The architecture is based on the Vitesse VSC7161* SAS Expander with enclosure management controller and has support for up to six SAS or SATA drives. The 4HDD and 6HDD SAS/SATA HSBP supports the following feature set: 1.5 Gbps and 3.0 Gbps self-configuring Serial Attached SCSI (SAS) Expander with embedded v3000 processor (Vitesse* Stanford-I 32-bit RISC CPU) for local control and Expander or enclosure management functions Non-volatile SPI Flash I2C_based EEPROM Temperature Sensor Two I2C interfaces SAS, SATA and SATA-II extension compatible Compliance with SCSI Enclosure Service (SES) specification Compliance with Intelligent Platform Management Interface (IPMI) 1.5 Support for up to six SAS 3.0GHz/1.5GHz, SATAII or SATAI Drives Hot Swap Drive support Two 4-pin Standard HD Power Connectors Revision: 1.0 63