Intel SRCS28X User Manual - Page 18
Inserting the Intel, Raid Controller SRCS28X in a PCI-X Slot - firmware
UPC - 735858171625
View all Intel SRCS28X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Hardware Installation Figure 3. Inserting the Intel® Raid Controller SRCS28X in a PCI-X Slot Bracket Screw Press Here Press Here Edge of Mother Board 64-bit Slots (3.3 V) 6. Screw the bracket to the computer frame. 7. Configure the Serial ATA devices and install them in the host system computer case. See the documentation for the Serial ATA device for any pre-installation configuration requirements. 8. Connect the Serial ATA cables between the Intel® Raid Controller SRCS28X and the Serial ATA devices. Chapter 4, "Intel® Raid Controller SRCS28X Characteristics," shows the connector locations on the Intel® Raid Controller SRCS28X. 9. Replace the computer cover and power up the system. Replace the computer cover and reconnect the power cords. Turn power on to the computer. The BIOS configuration utility prompt times out after several seconds. The second portion of the BIOS message displays the number, firmware version and cache SDRAM size. The numbering of the controller follows the PCI slot scanning order used by the motherboard. 18 Intel® Raid Controller SRCS28X User Manual