Intel SRCSASPH16I Hardware User Guide - Page 20

Configuring the Storage Adapter After performing the Intel® RAID Controller SRCSASPH16I installation, you must configure the storage adapter and install the operating system driver. The Software User's Guide instructs you on the configuration options and how to set them on your RAID Controller SRCSASPH16I, and provides detailed installation instructions for operating system drivers. Replacing a Controller Perform the following steps to replace a failed controller. 1. Power off the computer and all drives, enclosures, and system components. Remove the power cord. 2. Remove the chassis cover and access the PCI Express add-in card slots. See your server documentation for instructions. 3. Disconnect the cable(s) from the RAID controller. 4. Remove the failed controller from the system. 5. Insert the replacement controller into the system. Follow the instructions under Installation. Resolving a Configuration Mismatch If a replacement RAID Controller SRCSASPH16I has a previous configuration, a message displays during POST stating that there is a configuration mismatch. A configuration mismatch occurs when the configuration data in the NVRAM and the hard disk drives are different. You need to update the configuration data in the NVRAM with the data from the hard disk drive. Perform the following steps to resolve the mismatch. 1. Press when prompted during the boot process to access the BIOS Configuration Utility. 2. Select Configure->View/Add Configuration. This allows viewing of the NVRAM and drive configurations. 3. Select the configuration on disk because the drives contain the correct configuration. 4. Press and select YES to update the NVRAM. 5. Exit and reboot. 11 Intel® RAID Controller SRCSASPH16I Hardware Guide