Intel SRCSATAWB User Guide - Page 16

Technical Specifications - raid card

Page 16 highlights

Technical Specifications Specification Processor Operating foltage Card size Array interface to host SATA bus speed Serial port SATA controller SATA ports Physical and virtual drive support Cache Firmware Compatible devices Cabling Redundant configuration Enclosure management Enclosure support Array support Intel® RAID Controller SRCSATAWB LSI* 1078 Integrated RAID on Chip 500 MHz +3.3 V, +12 V Low profile, extended half-length (7.71-inch x 2.536-inch) PCI Express* Rev 1.0A, x4 lane width 2.5 Gbps 3 Gbps per port, point-to-point 3-pin RS232-compatible connector for debug use only LSI 1078 2x4 internal ports, 16 devices per port with expanders 16 drives per controller; 32 virtual drives per controller; 16 hot spares per controller (global and/or dedicated) 128 MBs DDR2 667 MHz SDRAM, optional battery backup 4 M in reflashable flash ROM 2.5-inch and 3.5-inch SATA 3.0 drives; non disk devices including expanders and drives of mixed capacity. Small, thin cables do not restrict airflow; Shared connectors for multiple drives 32 Kb NVRAM and config-on-disk (COD) In-band and out-of-band SES2 Assumes one SEP per enclosure 128 arrays per controller; 16 drives per array; 16 virtual drives per array. 11 Intel® RAID Controller SRCSATAWB Hardware User's Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34

11
Intel® RAID Controller SRCSATAWB Hardware User’s Guide
Technical Specifications
Specification
Intel
®
RAID Controller SRCSATAWB
Processor
LSI* 1078 Integrated RAID on Chip 500 MHz
Operating foltage
+3.3 V, +12 V
Card size
Low profile, extended half-length (7.71-inch x 2.536-inch)
Array interface to host
PCI Express* Rev 1.0A, x4 lane width 2.5 Gbps
SATA bus speed
3 Gbps per port, point-to-point
Serial port
3-pin RS232-compatible connector for debug use only
SATA controller
LSI 1078
SATA ports
2x4 internal ports, 16 devices per port with expanders
Physical and virtual drive
support
16 drives per controller; 32 virtual drives per controller; 16 hot
spares per controller (global and/or dedicated)
Cache
128 MBs DDR2 667 MHz SDRAM, optional battery backup
Firmware
4 M in reflashable flash ROM
Compatible devices
2.5-inch and 3.5-inch SATA 3.0 drives; non disk devices
including expanders and drives of mixed capacity.
Cabling
Small, thin cables do not restrict airflow; Shared connectors for
multiple drives
Redundant configuration
32 Kb NVRAM and config-on-disk (COD)
Enclosure management
In-band and out-of-band SES2
Enclosure support
Assumes one SEP per enclosure
Array support
128 arrays per controller; 16 drives per array; 16 virtual drives
per array.