Intermec 6822 6820 Series 80-Column Printer Terminal Holder Installation Instr - Page 9
Series 80-Column Printer Terminal Holder Installation Instructions
![]() |
View all Intermec 6822 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Holder ribbon cable To printer mechanism Screw (4 places) Printer mechanism removed for clarity CK61 holder only Location 2 Location 1 Disconnecting the CK61 Holder Cables: In addition to the ribbon cable, the CK61 holder (shown above) may also have a ground cable attached at Location 1 or Location 2. 5 Tilt the printer mechanism back into place. 6 Remove the four flathead screws that secure the existing holder to the printer. 7 Lift the holder from the printer. The holder is still connected to the printer by a ground cable. 8 Disconnect the ground cable and carefully pull the ribbon cable out from under the printer mechanism. You may need to lift the mechanism out of the way. 6820 Series 80-Column Printer Terminal Holder Installation Instructions 9
![](/manual_guide/products/intermec-cn70-6820-series-80column-printer-terminal-holder-installation-instructions-79e55af/9.png)