Intermec PB42 CK60 and PB42 Battery Instructions - Page 1

Design and specifications are subject to change without notice. Rechargeable 17.3 Watt-hour, 7.2 V lithium-ion battery (Model AB11) 70 x 41 x 25 mm (2.8 x 1.6 x 1.0 in) 116.5 g (4.1 oz) Specifications Physical Specifications Capacity and Output Specifications Maximum output: x 8.4 V Nominal output: x 7.4 V 2.4 Ah Temperature and Humidity Specifications Operating temperature: -20°C to 50°C (-4°F to 122°F) Charging temperature: 0°C to 40°C (32°F to 104°F) -30°C to 60°C (-22°F to 140°F) 5% to 95% non-condensing Note: In the U.S.A., the EPA does not consider spent Li-ion batteries as hazardous waste. Caution: This battery pack may ignite, create a chemical burn hazard, explode, or release toxic materials if mistreated. Do not incinerate, disassemble, or heat above 100°C (212°F). Do not short circuit; may cause burns. Keep away from children. Use only Intermec charger Models AC4, AC10, AD3, AD4, AD5, AD6, AV3, CK60 and PB42. Use of incorrect charger may present a risk of fire or explosion. CONTAINS LITHIUM-ION BATTERY. WASTE BATTERY MUST PROMPTLY BE RECYCLED OR DISPOSED OF PROPERLY. SEE INSTRUCTIONS. Proper Disposal of Waste Batteries Some of the substances necessary for the proper functioning of batteries are considered harmful to the environment and to human health. It is therefore important that those substances be kept out of the environment. You play an important role in the protection of the environment: 1. Keep all waste batteries out of unsorted trash. 2. Dispose of all waste batteries in separate collection for treatment and recycling. Please contact Intermec for the collection option(s) available in your location. Marking of the battery: 1. The wheeled-bin symbol indicates the requirement for separate collection of the battery. 2. Two letters shown underneath the wheeled bin indicate the presence of a certain substance: a. Hg means Mercury is present b. Cd means Cadmium is present c. Pb means Lead is present 3. The Moebius loop (chasing arrows) indicates that the battery is recyclable. Worldwide Headquarters 6001 36th Avenue West Everett, Washington 98203 U.S.A. tel 425.348.2600 fax 425.355.9551 www.intermec.com © 2009 Intermec Technologies Corporation. All rights reserved. CK60 and PB42 Battery (Model AB11) Instructions *943-072-002* P/N 943-072-002 Product : Dimensions: Storage temperature: Weight : Capacity : Relative humidity: Important Recommendations y Charge the battery before use. y See "Charging the Battery" for approved charging methods. Use of this battery in other devices could result in damage to the device or battery. y The temperature range for charging batteries is 0°C to 45°C (32°F to 113°F). Do not charge battery packs outside this range. For maximum battery life, charge batteries at 23°C (73°F). y Do not store the battery at temperatures above 60°C (140°F), such as inside a car on a hot day or in direct sunlight, as this may damage the battery. y Battery usage by children should be supervised. y Do not disassemble or open, crush, bend or deform, puncture, shred, or burn. y Do not modify the battery or attempt to insert foreign objects into the battery. y Do not solder directly to the battery contacts. y Do not immerse the battery in water. y Do not short circuit the battery. Keep the battery connector away from metallic items. y Do not apply mechanical shocks or pressure to the battery. y Avoid dropping the battery or the CK60 or PB42. If you suspect that the battery or CK60 or PB42 is damaged, send it to an Intermec service center for inspection. y Replace battery only with another AB11 battery. This battery has been tested in accordance with applicable safety standards. Contact your Intermec sales representative or distributor if this battery is no longer available. y Discarded batteries may create a safety hazard. Before disposal, cover the battery connector with electrical insulating tape. CK60 & Battery (Model AB11) Instructions PB42 The Model AB11 battery (P/N 318-015-002) is a rechargeable 17.3 Watt-hour, 7.2 V, Lithium-ion (Li-ion) battery. Charging the Battery You need to fully charge the battery before using it in your CK60 mobile computer or PB42 portable receipt printer. A fully discharged battery charges in less than 4 hours. Charging Accessory CK60 4-Position Battery Charger PB42 4-Bay Battery Charger CK60 4-Position Communications Dock CK60 4-Position Charge-Only Communications Dock CK60 Ethernet/USB Communications Dock CK60 Modem/USB Communications Dock CK60 Vehicle Dock CK60 Mobile Computer PB42 Portable Receipt Printer Model AC4 AC10 AD3 AD4 AD5 AD6 AV3 CK60 PB42