Intermec PD41 EasyLAN Ethernet Software for PD41/PD42 Instructions - Page 9

Setting Network Parameters with Fingerprint Commands If your printer is running Fingerprint firmware, you can modify all network parameters with the Fingerprint Setup command. To modify network parameters with Fingerprint commands 1 Establish a serial connection between your computer and printer, as described on page 8. 2 Switch user to administrator with the default login (username: admin, password: pass). RUN su -p pass admin 3 Set the IP selection method to manual: SETUP "NETWORK,IP SELECTION,MANUAL" 4 Set the IP address (values are examples only): SETUP "NETWORK,IP ADDRESS,192.168.235.860" 5 Set the netmask, default router and name server (values are examples only): SETUP "NETWORK,NETMASK,255.255.255.0" SETUP "NETWORK,DEFAULT ROUTER,192.168.236.1" SETUP "NETWORK,NAME SERVER,255.255.78.120" Once you have set the parameters above you can use your web browser to access the printer home page and make the rest of your changes there. Setting Network Parameters with IPL commands If your printer is running IPL firmware, you can modify various setup parameters with the IPL command. To modify network parameters with IPL commands 1 Establish a serial connection between your computer and printer, as described on page 8. 2 To set IP address and use default values for netmask and router, use this command (values are examples only): n192.168.235.860 3 To set the IP address, netmask, and default router values (values are examples only): EasyLAN Ethernet Software Instructions 9