Invacare M91-TS Owners Manual - Page 19
Operating The, Power Tilt Only
View all Invacare M91-TS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
SEAT ASSEMBLY SEAT ASSEMBLY SECTION 3 This Procedure Includes the Following: Operating The Power Tilt Only Tilting The Seat Assembly OPERATING THE POWER TILT ONLY (FIGURE 1) WARNING NEVER operate the wheelchair while in any tilted position over 20o RELATIVE TO THE VERTICAL POSITION. If the drive lock-out does not stop the wheelchair from operating in a tilt position 20o RELATIVE TO THE VERTICAL POSITION, DO NOT operate the wheelchair. Have the wheelchair serviced by a dealer or qualified technician. A NOTE ABOUT DRIVE LOCK-OUT Drive lock-out is a feature designed to prevent the wheelchair from being driven after the seating system has been tilted beyond 20o*. When the drive lock-out feature has been activated, the LED on the single function toggle switch will light. *NOTE: 20o of tilt can be any combination of back angle and tilt. NOTE: The tilt range is from 0o to 45o with a 0o seat-to- floor angle and 5o to 50o with a 5o seat-to-floor angle. INCREASING THE TILT ANGLE 1. Make sure the wheelchair is on a level surface. 2. Push the single function toggle switch forward towards the front of the wheelchair until the desired angle is achieved. DECREASING THE TILT ANGLE 1. Pull the single function toggle switch back towards the rear of the wheelchair until the desired angle is achieved. Tilt Single Function Toggle Switch FIGURE 1 - OPERATING THE TILT FUNCTION Part No. 1118362 Rev A 19 Power Tilt Only For M71 and M91.