Invacare M91-TS Owners Manual - Page 23

SEAT ASSEMBLY SEAT ASSEMBLY SECTION 4 CHARGING USING AN INDEPENDENT CHARGER (FIGURE 1) NOTE: The charger port located on the FRONT of the joystick requires the use of an independent charger. WARNING READ and CAREFULLY follow the individual instructions for each charger (supplied or purchased). If charging instructions are not supplied, consult a qualified technician for proper procedures. CAUTION DO NOT use an independent charger rated for over 8 amps. Otherwise, damage may occur. Required Items: MODEL Battery Charger * Power Cord M91 and M71 Supplied Supplied * NOTE: AC power cord (3-prong plug, 15 ampere current rating; industrial type) 1. Perform one of the following: A. Wheelchair with RII JOYSTICK: • Attach the battery charger connector to the charger port on the FRONT of the joystick. B. Wheelchair with "A" JOYSTICK (MKIV electronics): • Attach the battery charger connector to the charger port as shown in FIGURE 1. 2. Plug the charger’s AC power cord, or extension, into the grounded 110-volt wall outlet. 3. Switch Charger ON. 4. Wait until charging is complete. 5. When charging is compleate, switch charger off and disconect from wall outlet and wheelchair. RII JOYSTICK "A" JOYSTICK (MARK IV ELECTRONICS) Charger Port Independent Charger Port FIGURE 1 - CHARGING USING AN INDEPENDENT CHARGER Part No. 1118362 Rev A 23 Power Tilt Only For M71 and M91.