Invacare R51 Owners Manual - Page 35
Replacing Heel Loops
View all Invacare R51 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
SECTION 6-FRONT RIGGINGS Model 93M, 904A, PAL4A, and PAS4A Footrests NOTE: For this procedure, refer to FIGURE 6.3. 1. Loosen, but do not remove the lug bolt and locknut that secure the lower footrest to the footrest support. 2. Reposition the lower footrest to the desired height. 3. Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest support. 4. Repeat STEPS 1-3 for the other footrest, if necessary. Lug Bolt Footrest Support Locknut Lower Footrest NOTE: 93M style footrest shown. 904A, PAL4A and PAS4A footrests adjust the same way. FIGURE 6.3 Adjusting the Footrest Height - Model 93M, 904A, pal4a, and PAS4A Footrests Replacing Heel Loops NOTE: For this procedure, refer to FIGURE 6.4. 1. Note the position of hex bolt, coved washers and locknut for reinstallation. 2. Remove the hex bolt, coved washers and locknut that secure the lower footrest to the footrest support. 3. Remove the lower footrest. 4. Remove the phillips bolt, spacer and locknut that secure the existing heel loop to the lower footrest. Locknut Coved Washers Lower Footrest Footrest Support Hex Bolt Phillips Bolt Spacer Heel Loop 5. Slide the existing heel loop off the lower footrest. 6. Replace heel loop. 7. Reverse STEPS 1-6 to reassemble. Locknut FIGURE 6.4 Replacing Heel Loops NOTE: When securing heel loop to lower footrest, tighten the phillips screw and locknut until the spacer is secure. Part No. 1106645 35 R51™and R51LXP