Invacare TILTSYS Owners Manual 2 - Page 66
Adjusting/Replacing Telescoping Front Rigging Support
View all Invacare TILTSYS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
SECTION 6-FRONT RIGGINGS Adjusting/Replacing Telescoping Front Rigging Support Wheelchairs without 2G Tarsys Systems NOTE: For this procedure, refer to FIGURE 6.6. 1. Remove the two cap screws, spacers and threaded blocks securing the telescoping front tube to the side rail. 2. Perform one of the following: • Slide existing telescoping front rigging support to one of six depth positions. • Remove existing telescoping front rigging. 3. Secure the telescoping front tube to the side rail at the desired depth with the existing two cap screws, spacers and threaded blocks. 4. Repeat STEPS 1 to 3 on the opposite side, if desired. Side Rail Spacers Cap Screws Side Rail Cap Screws Spacers Threaded Blocks Telescoping Front Tube FIGURE 6.6 Adjusting/Replacing Telescoping Front Rigging Support - Wheelchairs without 2G Tarsys Systems 3G Storm Series® Wheelchairs 66 Part No 1134791