Invacare TRAN19FR Owners Manual - Page 16

SECTION 4-FRONT RIGGINGS SECTION 4-FRONT RIGGINGS ƽ WARNING After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise, injury or damage may result. Installing Swingaway Footrest Assembly NOTE: For this procedure, refer to FIGURE 4.1. 1. Turn the footrest to the side (open footplate is perpendicular to transport chair). 2. Install the hinge plates on the footrest onto the hinge pins on the transport chair frame. 3. Push the footrest towards the inside of the transport chair until it locks into place. NOTE: The footplate will be on the inside of the transport chair when locked in place. 4. Repeat this procedure for the other footrest assembly. 5. To release the footrest, push the footrest release lever inward, rotate the footrest outward. Hinge Pins Footrest Release Lever Hinge Plates Swingaway Footrest Assembly FIGURE 4.1 Installing Swingaway Footrest Assembly Adjusting Footplate Height NOTE: For this procedure, refer to FIGURE 4.2. 1. Remove the swingaway footrest assembly. Refer to Installing Swingaway Footrest Assembly on page 16. NOTE: Lay the assembly on a flat surface to simplify this procedure. 2. Loosen, but DO NOT remove, the footplate mounting bolt until the footplate assembly moves freely. 3. Reposition the footplate assembly to the desired height. 4. Securely tighten the footplate mounting bolt. 5. Repeat this procedure for the other footrest, if necessary. 6. Reinstall the swingaway footrest assembly. Refer to Installing Swingaway Footrest Assembly on page 16. Upper Footrest Support Footplate Assembly Footplate Mounting Bolt FIGURE 4.2 Adjusting Footplate Height Transport Chairs 16 Part No.1125095