Invacare TRHD22FR Owners Manual - Page 5

LABEL LOCATIONS LABEL LOCATIONS Bariatric Transport Invacare Transport, Lightweight Transport, and Lite Transport NOTE: This label is only on the Lite transport. View From Back of Chair NOTE: The Lightweight transport is shown as an example. Unless indicated on this page, label locations and wording are the same for the Invacare transport and the Lite transport NO TRANSPORT CHAIR HAS BEEN APPROVED FOR USE AS A SEATING SURFACE WITHIN A MOTOR VEHICLE. THIS LABEL IS FOR INFORMATIONAL PURPOSES ONLY. LIABILITY ISSUES WERE NOT CONSIDERED IN THE ATTACHMENT OF THIS LABEL. AUCUNE CHAISE ROULANTE N'A ETE APPROUVEE POUR UTILISATION COMME SIEGE DANS UN VEHICULE MOTORISE. CETTE ETIQUETTE EST POUR INFORMATION UNIQUEMENT. LES QUESTIONS DE RESPONSABILITE N'ONT PAS ETE PRISES EN LIGNE DE COMPTE DANS LE CADRE DE L'APPLICATION DE CETTE ETIQUETTE. 1143180 Rev A - 4/26/06 Part No.1125095 5 IMPORTANT NOTICE The wheel locks on this transport chair have been pre-set at the factory to comply with the Veterans Administration functional Standard 8320.01 of the Federal Register, paragraph 3.2.4.5.3. If these wheel locks do not meet your needs, follow instructions below. ! CAUTION Any wheel lock adjustments should embed wheel lock shoe at least 1/8" into tire when locked (3/16" on pneumatic tires). INSTRUCTIONS FOR WHEEL LOCK ADJUSTMENTS 1. Loosen wheel lock mounting fastener, which runs through mounting bracket and frame. 2. Slide clamp toward rear wheel until wheel lock shoe is embedded into tire material at least 1/8" when handle is engaged to the lock position (3/16" for pneumatic tires). 3. Tighten mounting fastener to secure mounting bracket in desired location and recheck lock shoe embedding. 4. Inspect for correct locking action BEFORE actual use. P/N 1143193 REV A Transport Chairs