JBL ON STAGE Owners Manual Multilingual - Page 6

on stage Easy Setup Guide Step 1. Unpack on stage, wall adaptor, iPod adaptors and cable. Read this instruction sheet completely. Step 2. Choose correct iPod Step 3. Plug power adaptor into on Step 4. If using iPod with bottom adaptor type. Press iPod adaptor stage. Connect adaptor to wall out- connector, dock iPod into front into on stage. let. connector of on stage. on stage specifications* Troubleshooting Symptom Possible problem Frequency range: 100Hz-20kHz Power consumption: 20W maximum Transducers: (2) 1-inch full range per channel Amplifier output power: 6 Wrms per channel No sound from on stage speaker system. No power to system. Power adapter plug not inserted correctly. No volume or low volume. Dimensions: 6.75" (17.1 cm) diameter 1.5" (3.8 cm) tall Weight: 1.1 pound = 0.5 kg Sound quality can be affected by the amount of file compression. Input source is low. USE ONLY JBL approved power supplies listed on the product label. Clicking/Ticking noise from speakers Incorrect power supply plugged into A/C jack or firewire port. Solution Ensure power supply is connected to live power source and properly connected to on stage. Please note: When on stage is powered, a green power LED should illuminate. Touch the volume "Up" (+) pad on the volume control to unmute and/or increase the system volume level. Note: Touching the volume "Down" (-) pad lowers the system volume. Touching both (+) and (-) volume control pads at the same time will mute the system. Increase the volume level on the audio source device. Disconect non-JBL power supply. If you have any questions, or need further assistance, please visit www.JBL.com. *These specifications are subject to change without notice. 6