JET Tools ESR-1650-1T User Manual - Page 11
Troubleshooting the ESR-1650T Slip Roll, Replacement Parts
View all JET Tools ESR-1650-1T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
13.0 Troubleshooting the ESR-1650T Slip Roll Trouble Probable Cause No incoming power. Slip roll doesn't operate; rolls won't move. Cones are made when trying to make cylinders. Workpiece is not bending. Emergency stop engaged. Jam nut is loose. Gears damaged. Rolls not parallel. Machine capacity exceeded. Idle Roll not engaging. Remedy Check power source and connections. Release emergency stop switch by rotating clockwise (check both switch locations). Tighten nut to secure stationary roll. Inspect gears; repair/replace as needed. Adjust idle (rear) roll as needed until idle roll is parallel to stationary (top) roll. Use materials within machine's capacity. Inspect idle roll; make adjustments as needed. 14.0 Replacement Parts Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-800-274-6848, Monday through Friday (see our website for business hours, www.jettools.com). Having the Model Number and Serial Number of your machine available when you call will allow us to serve you quickly and accurately. 11