JVC CSBB2 Instructions - Page 2

CONNECTIONS When using speaker input terminal NOTES: • The volume of this unit is set to the maximum when the remote controller is not connected. • If your receiver is equipped with the DSP (Digital Signal Processor), connect this unit to the front speaker output of the receiver. When using LINE IN jacks NOTES: • The volume of this unit is set to the maximum when remote controller is not connected. • If your receiver is equipped with the DSP (Digital Signal Processor), connect this unit to the Front Line Output jacks of the receiver. • When connecting to the Line Output jacks, make sure that the output level of the receiver is 2 V or lower; otherwise, sounds will be distorted. Cautions • Ground wire connection Ground wire • Do not cut off the fuse; otherwise, it may be short-circuited, and cause a fire. Fuse The fuse is cut off. Firmly attach the ground wire to the metallic body or to the chassis of the car-to the place uncoated with paint (if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit. • Do not connect the power lead to any other sources than the battery. • Do not connect the blue with white stripes to any other wire than the remote out (DC 12 V) and ACC power. After connection, reconnect the battery negative terminal and make sure stop lamps and others can operate normally. 2