JVC DLA-G20U DLA-G20U User instruction manual (2.6MB) - Page 7
Controls and Features - lens
View all JVC DLA-G20U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Controls and Features Front Side / Top Surface / Right Side q 1 p 9 87 6 5 43 2 1 Exhaust vents Vents for cooling fans through which warm air comes out. CAUTION • Do not block the exhaust vents, or heat builds up inside, possibly causing a fire. Also, do not touch the vents, or this could cause a low-temperature burn. 2 Carrying handle Raise this handle when carrying the projector. CAUTIONS • When carrying the projector, do not give a shock to it. Be careful to keep its balance. • Do not carry it while the light source lamp is on or the cooling fan is operating. This could cause personal injury. How to use the carrying handle 6 Adjustable foot (for horizontal angle adjustment) By extending the feet, the projector angle can be adjusted up to +7°. AUDIO PC VIDEO Y/C AUDIO R AUDIO L R H/CS G B COMPUOTEURT V REMOTE Y PB/B-Y PR/R-Y AUDIO OUT RS-232C +7° • Extending the front adjustable foot While pushing the lever, raise the projector, and lever the adjustable foot extends automatically. To retract the foot, pushing the lever, lower the projector slowly; the projector is fixed at the position where you release the lever. 7 Built-in speaker (left) Carrying handle 3 AC IN (power input) terminal This is the power input terminal where the supplied power cord is connected. For details, refer to page 24. 4 Fuse holder A fuse rated 15A/250V is installed. (Power source protection) To replace the fuse, use a fuse with the same specifications. 5 MAIN POWER switch This is the main power switch. When it is turned on, the projector goes into stand-by state, and the STAND BY indicator on the control panel comes on. ON [ ]: The main power turns on. OFF [‡]: The main power turns off. 6 8 Built-in speaker (right) 9 Lens Projection lens, which is an electrically driven, approx. 1.5 x zoom lens. Before projection, remove the lens cap. p Lens cap The cap has a string attached and the string is fixed to the projector when shipped from the factory. It is recommended that the cap be fitted on to prevent the lens becoming dirty when the projector is not used. q Remote sensor When operating with the remote control, aim it toward this sensor.You can also operate the remote control by pointing it to a screen and allowing the remote sensor to receive the reflected light.