JVC DRMV100B Instructions - Page 14

Connections to your TV Make one of the following connections, depending on the capabilities of your TV. RF coaxial connection Connect the ANTENNA OUT jack on the Recorder to the antenna in jack on the TV using the supplied 75ohm Coaxial Cable (R). Video connection Connect the VIDEO OUTPUT jack on the Recorder to the video in jack on the TV using the video cable supplied (V). Note: If you use this connection, set the TV's source selector to VIDEO. S-Video connection Connect the S-VIDEO OUTPUT jack on the Recorder to the S-Video in jack on the TV using the optional S-Video cable (S). Notes: • Set the resolution to 480p using OUTPUT STATUS button on the front panel for progressive signal. • Progressive Scan does not work with the RF, Video or S-Video connections. • If your TV does not accept the Progressive Scan format, the picture will appear scrambled. • If the resolution is set to 720p, 1080i or 1080p, the VIDEO OUTPUT, S-VIDEO OUTPUT and COMPONENT OUTPUT connections are not available. Audio connection Connect the Left and Right AUDIO OUTPUT jacks on the Recorder to the audio left/right in jacks on the TV using the supplied audio cables (A1 or A2). Rear of TV S-VIDEO INPUT COMPONENT/PROGRESSIVE SCAN VIDEO INPUT AUDIO INPUT Pr Pb Y R L S C A2 Component Video connection If your television is a high-definition or "digital ready" television, you may take advantage of the Recorder's progressive scan output for the highest video resolution possible. Connect the COMPONENT OUTPUT jacks on the Recorder to the corresponding in jacks on the TV using an optional Y PB PR cable (C). Rear of Recorder R V A1 Rear of TV 10