JVC DT-V24L3DU Instruction Manual - Page 13

Operation guide Shows the buttons for each operation. NOTE Example of the wave form monitor Ex.: When "MARKING" is set to "ON" and "LEVEL" is set to "080" Red White • The wave which goes over the value set on "LEVEL" is indicated in Red. WAVE FORM SETTING*1 Settings for the wave form monitor Item To do Setting value POSITION Select the position of the wave form monitor. 1 (lower right), 2 (lower left), 3 (upper left), 4 (upper right) FILTER Activates/deactivates the low-pass filter for the incoming wave form data. FLAT (no filter), LOWPASS GAIN Adjust the gain level for the incoming wave form -10 - +10 data. OVER LEVEL Select the over level for the incoming luminance ☞ "NOTE" signals. MARKING Activates/deactivates the function to change the OFF, ON color of a wave form when the signal exceeds the limit specified on "LEVEL" (☞ below). LEVEL Adjust the lower limit for the luminance signal 070 -109 AUTO OFF Activates/deactivates the function to make the ON, OFF wave form monitor indication go off automatically 15 minutes after displaying it. *1 This function does not work for the signals as follows: RGB input signals (analog/digital), DVI signals (digital/inputted from personal computer), 1080/60p (analog/digital), 1080/50p (analog/digital), 640 *480/60p (analog/digital). SYNC FUNCTION Settings for the synchronization with signals Item NO SYNC ACTION DELAY TIME SYNC INPUT SEL.*2 LOW LATENCY To do Select the screen status when no signal is coming in. Select the period until the screen status changes as selected in "NO SYNC ACTION" after signals stop coming in. Select the sync signal for the VIDEO1, VIDEO2 and COMPO./RGB input. Activates/deactivates the function to shorten the time taken to display the picture (low latency function). • If the picture is not displayed steadily while "ON" is selected, select "OFF." • While "ON" is selected, the displayed picture may become unstable when an operation using buttons on the front panel or the menu is performed, or when the signal format changes. Setting value OFF, P.SAVE (power save mode), GRAY B. (gray screen) 30sec., 5min., 15min. INT. (Internal sync), EXT. (External sync) ON, OFF • When setting "NO SYNC ACTION" to "GRAY B.," the screen color changes to gray and the power consumption of the back light is saved by half. Selecting "P.SAVE" (power save mode) saves more power consumption by turning off the back light. *2 Memorized for each input. Video signal Start End 13