JVC EX D1 Instructions - Page 9
Setting the manufacturer's code, For TV operation, Getting started - remote
UPC - 046838017995
View all JVC EX D1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
This page is for when operating your TV using the remote control of this product. Operating the TV using the remote control Getting started Manufacturer Code JVC 01 Hitachi 10 Magnavox 02 Mitsubishi 03 Panasonic 04, 11 Philips 15 RCA 05 Manufacturer Code Samsung 12 Sanyo 13, 14 Sharp 06 Sony 07 Toshiba 08 Zenith 09 NOTE Manufacturer's codes may be changed without notice. You may not be able to operate a TV produced by the manufacturer shown above. 5 Release TV. For TV operation Operate the remote control by pointing it towards the TV. Turn ON/OFF the power. Change channels. Adjust volume. Setting the manufacturer's code 1 Slide the remote control mode selector to the TV side. 9 Select channels. 100+ *1 Alternates between the previously selected channel and the current channel. Switch TV and video input. 2 Keep pressing down TV. NOTE Keep pressing down TV until Step 4 is complete. 3 Press ENTER. 4 Press number buttons (1-9, 0). *1 Make sure to slide the remote control mode selector to the TV side in advance. NOTE When the batteries are replaced, perform the manufacturer's code setting again. Ex.: For a Hitachi TV: Press 1, then 0. For a Toshiba TV: Press 0, then 8. If there are more than one manufacturer's codes, try them in turn and select the one that causes the product to work properly. 7