JVC FS-SD550 User Manual - Page 14

Using the Tuner Presetting Stations You can preset up to 30 FM stations and up to 15 AM stations using the Remote Control. • Preset numbers may have been set to factory test frequencies prior to shipment. This is not a malfunction. You can preset the stations you want into memory by following one of the presetting methods below. Manual Presetting FM / AM When changing the Band SET STORED SET UP DOWN SET or FM = 30, AM = 15 1 Select a band by pressing the FM/AM button. 2 Press the 4 or ¢ button to tune in a station. 3 Press the SET button. "SET" will blink for 5 seconds. Within 5 seconds, proceed to the next step. When the display returns to the one set in step 2 after 5 seconds, press the SET button again. 4 Press the UP, DOWN, >, or < button within 5 seconds to select the preset number. UP or DOWN button:Increase or decrease the preset number by 1. Pressing and holding the button will continuously increase or decrease the preset number. > or < button: Increase or decrease the preset number by 1. Pressing and holding the button will rapidly increase or decrease the preset number. 5 Press the SET button within 5 seconds. "STORED" appears and after 2 seconds, the display returns to the broadcast frequency display. 6 Repeat above steps 1 to 5 for each sta- tion you want to store in memory with a preset number. To change the preset stations, repeat the same steps as above. Auto Presetting In each band, you can automatically preset FM-30, AM-15 stations. Preset numbers will be allocated as stations are found, starting from the lowest frequency and moving up the frequency. FM / AM AUTO PRESET (for 2 seconds) 1 Select a band by pressing the FM/AM button. 2 Press the AUTO PRESET button on the Remote Control for more than two seconds. 3 Repeat steps 1-2 for the other band. s If you want to change the preset stations, carry out the Manual Presetting for the desired preset numbers. CAUTION: • Even if the system is unplugged or if the power failure occurs, the preset stations will be stored for about 24 hours. However, in case the preset stations are erased, you will need to preset the stations again. To Change the FM Reception Mode When you are tuned into an FM stereo broadcast, the "STEREO" indicator lights up and you can hear stereo effects. If an FM stereo broadcast is hard to receive or noisy, you can select Monaural mode. Reception improves, but you lose stereo effect. Press the FM MODE button on the Remote Control so that the "MONO" indicator lights up on the display. FM MODE MONO To restore the stereo effect, press the FM MODE button on the Remote Control so that the "MONO" indicator goes off. 12