JVC GY-HM700U 132 page operation manual for the GY-HM700 solid state camcorder - Page 127
Tally Lamps, Alarm Tone, Error Display, Status, Action, Status Screen, Menu/Thumbnail, Screen
View all JVC GY-HM700U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Error Display Status Screen Menu/Thumbnail Screen EXT-RECORDER ^ POWER ? VIDEO FORMAT ^ INCORRECT MEDIA FULL ^ FAN MAINTENANCE ^ REQUIRED Status Action Power of the camera recorder is turned off while the external device connection is detected, and the same connection cannot be detected several seconds after power is turned on again. (Error displays for about 7 seconds) ● Video format of the file for Clip Review is different from the [Frame & Bit Rate] setting of the camera recorder. ● IEEE1394 input video format is different from the [Camera Resolution] and [Frame & Bit Rate] settings. ● [HD/DV] terminal mode switch is not correctly set for IEEE1394 input signals. ● [REC] button is pressed when the media in use has no remaining space. ● Remaining space ran out during recording. ● Usage time of the fan has exceeded 9000 hours. When making use of a connected external device, turn on the power supply on the connected device. Set [Camera Resolution] and [Frame & Bit Rate] correctly. (A Page 71) Set the [HD/DV] terminal mode switch according to the IEEE1394 input signals correctly. Replace the SDHC card with a new one. Check the fan and replace accordingly. For more details, consult your nearest JVC dealer. Memo: ● You can check the usage time of the fan at [Others]B[System Information]B[Fan Hour]. (A Page 88) Tally Lamps The tally lamps start blinking when the remaining space on the SDHC card is running out during recording, or when the battery power is running low. Blinking Mode Blinks slowly (Once every second) Blinks quickly (4 times a second) Remaining Battery Power/SDHC Card Space ● Battery power is low ● Remaining recording time on SDHC card is less than 3 minutes ● SDHC card is full ● Error on the camera recorder Alarm Tone Alarm tone is output from the monitor speaker and [PHONES] terminal when the battery level is low. Alarm tone is output from the monitor speaker and [PHONES] terminal when the SDHC card is full. (Camera mode only) Alarm tone is also output when an error occurs in the camera recorder. Memo: ● [Alarm Level] in the [Others] menu can be used to specify whether alarm tone is to be output, as well as the volume level. (A Page 87) ● Alarm tone is not output during recording. 123