JVC KD-ADV38 Instructions - Page 305
Warnings - kd
UPC - 046838030499
View all JVC KD-ADV38 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 305 highlights
LVT1708-005A [U] KD-AVX33 Installation/Connection Manual 0207MNMMDWJEIN EN, CT, TH ©2007 Victor Company of Japan, Limited ENGLISH ˁ̂ ‰∑¬ This unit is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle does not have this system, a voltage inverter is required, which can be purchased at JVC car audio dealers. 12 V JVC 12 JVC WARNINGS ᙲѿ • DO NOT install any unit and wire any cable in locations where; - it may obstruct the steering wheel and gearshift lever operations, as this may result in a traffic accident. - it may obstruct the operation of safety devices such as air bags, as this may result in a fatal accident. - it may obstruct visibility. • DO NOT operate any unit while manipulating the steering wheel, as this may result in a traffic accident. • The driver must not watch the monitor while driving. If the driver watches the monitor while driving, it may lead to carelessness and cause an accident. • The driver must not put on the headphones while driving. It is dangerous to shut off the outside sounds while driving. • If you need to operate the unit while driving, be sure to look around carefully. • If the parking brake is not engaged, "Parking Brake" appears on the monitor, and no playback picture will be shown. - This warning appears only when the parking brake lead is connected to the parking brake system built in the car. Notes on electrical connections: • Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC car audio dealer. • It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 Ω to 8 Ω). If the maximum power is less than 50 W, change "Amplifier Gain" setting to prevent the speakers from being damaged (see page 51 of the INSTRUCTIONS). • To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape. • The heat sink becomes very hot after use. Be careful not to touch it when removing this unit. Parking Brake ቁώJVC 50 W 4 Ωü8 50 W Amplifier Gain 51 Parking Brake" JVC 50 W 4 Ω ∂÷ß 8 50 W Amplifier Gain 51 Heat sink ಞᇊ̕ Required space for installation Control panel Dashboard 5 mm 5 mm Trim plate is detached on this illustration for explanation Installing the remote controller Holder Parts list for installation and connection The following parts are provided for this unit. After checking them, please set them correctly A / B Hard case/Control panel C Sleeve ͙ࢭጅೋ D Trim plate ༫ྟख E Power cord F Audio/video cord G Crimp connectors қʪᏃ H Remote controller/Holder I Batteries ྐЖ J Double-sided adhesive tape K Microphone ఐџࡘ L Microphone clip ఐџࡘқ M Reverse gear signal extension cord N Washer (ø5) ࿑ (ø5) 5) Remote controller ჲ Double-sided adhesive tape o Lock nut (M5 M5) M5) P Handles Q Rubber cushion R Mounting bolt-M5 x 20 mm M5 × 20 mm M5 × 20 ¡¡. 1