JVC KD-R775S Instruction Manual - Page 16

AUDIO SETTINGS For KD-R775S HPF OFF: All signals are sent to the front/rear speakers. ; LOW 100HZ / MID 120HZ / HIGH 150HZ: Audio signals with frequencies lower than 100 Hz/ 120 Hz/ 150 Hz are cut off from the front/rear speakers. FADER R06 - F06 (00): Adjusts the front and rear speaker output balance. BALANCE *4 L06 - R06 (00): Adjusts the left and right speaker output balance. VOL ADJUST -15 - +06 (00): Preset the initial volume level of each source (compared to the FM volume level). Before adjustment, select the source you want to adjust. ("VOL ADJ FIX" appears if FM is selected.) AMP GAIN LOW POWER: Limits the maximum volume level to 25. (Select if the maximum power of each speaker is less than 50 W to prevent damaging the speakers.) ; HIGH POWER: The maximum volume level is 35. D.T.EXP (Digital Track Expander) ON: Creates realistic sound by compensating the high-frequency components and restoring the rise-time of the waveform that are lost in audio data compression. ; OFF: Cancels. TEL MUTING*5 ON: Mutes the sounds while using the cellular phone (not connected through KS-BTA100). ; OFF: Cancels. For KD-R670 / KD-R570 / KD-R470 / KD-R370 SPK/PRE OUT Depending on the speaker connection method, select the appropriate setting to get the desired output. ( Speaker output settings) *4 This adjustment will not affect the subwoofer output. *5 Does not work if [BT ADAPTER] is selected for [AUX] in [SRC SELECT]. ( 4) 16 Speaker output settings Select the output setting for the speakers [SPK/PRE OUT], base on the speaker connection method. Connection via lineout terminals For connections through an external amplifier. ( 25) (For KD-R670) Setting on [SPK/PRE OUT] Audio signal through lineout terminal FRONT REAR/SW REAR/REAR Front speakers output Rear speakers output REAR/SUB.W Front speakers output Subwoofer output SUB.W/SUB.W Front speakers output Subwoofer output (For KD-R570 / KD-R470 / KD-R370) Setting on [SPK/PRE OUT] Audio signal through lineout terminal REAR/SW REAR/REAR Rear speakers output REAR/SUB.W Subwoofer output SUB.W/SUB.W Subwoofer output Connection via speaker leads For connections without using an external amplifier. However, with this settings you can also enjoy the subwoofer output. ( 25) (For KD-R670 / KD-R570 / KD-R470 / KD-R370) Setting on [SPK/PRE OUT] Audio signal through rear speaker lead L (left) R (right) REAR/REAR Rear speakers output Rear speakers output REAR/SUB.W Rear speakers output Rear speakers output SUB.W/SUB.W Subwoofer output (Mute) If [SUB.W/SUB.W] is selected: - [HIGH 120HZ] is selected in [SUB.W LPF] and [THROUGH] is not available. - [R01] is selected in [FADER] and selectable range is [R06] to [00]