JVC KY-F70U KY-F70U Computer Imaging Camera Instructions (827KB) - Page 20
Connecting an MO drive unit
View all JVC KY-F70U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
2. Before recording (continued) Connecting an MO drive unit It is possible to output image data stored in the main unit memory to an MO drive unit. ( ੬ Page 36 Saving images from the memory to an MO disk) Dip switches @@@@@@ SCSI REC SEND AW/SEL MODE MENU UP DOWN SET PLAY FREEZE MONITOR LENS REMOTE ON 1 2 3 4 DC IN POWER SEE INSTRUCTION MANUAL SCSI terminal To directly connect the MO drive to the main unit, set the dip switches on the rear of the main unit as shown below. ON 1 2 3 4 (SCSI : 7) Do not set the ID of the MO drive side to other than 7. MEMO • The image data outputted to an MO drive will be 1360 × 1024 pixels, regardless whether the monitor in use is VGA or SXGA, or whether the VGA mode is set to FINE or DRAFT. • The maximum allowed length of the SCSI cable is 3m. • When connecting an MO drive to a PC, separate setting of the SCSI ID is required. ( ੬ Page 64 7. Connecting to a PC) • It is not possible to simultaneously output the image data to a printer and MO drive. E20