JVC KY-F70U KY-F70U Computer Imaging Camera Instructions (827KB) - Page 31

AW SCSI REC SEND AW/SEL MODE MENU UP DOWN SET PLAY FREEZE MONITOR LENS REMOTE ON 1 2 3 4 DC IN POWER SEE INSTRUCTION MANUAL AUTO WH I TE O PERA T I O N Auto white in operation AUTO W H I TE OK Auto white operation completed 6. After pressing the MENU button twice to return to the normal screen, place a white object with the same lighting conditions as the object to record, then zoom in to display white on the screen. 7. Press the AW (Auto White) button. ● When auto white is in operation, OPERATION will be displayed on the monitor screen. ● When the white balance is successfully set, OK will appear on the screen and the unit will return to the normal screen. MEMO When setting the VGA mode to FINE, using the SXGA mode or setting the unit to a slow shutter speed, the white balance operation may take some time before completion. ● Error display When the auto white balance cannot be set, one of the following error messages will appear and the unit will return to the normal screen. NG: OBJECT (bad object) Displayed when the object consists of little whiteness or when the color temperature is not correct. Change to a white object and redo the white balance. ERROR: LOW LIGHT (shortage of light) Displayed when the lighting is too dark. Brighten the lighting and redo the white balance. ERROR: OVER LIGHT (excessive light) • Displayed when the lighting is too bright. Lower the brightness and redo the white balance. • If the color temperature of the object changes when darkening the lighting, redo the white balance after pressing the AW button on the panel. E31