JVC M505 Instructions - Page 17
Speaker layout, Connecting a TV, To connect a TV equipped with the component video, input jacks - powered subwoofer
UPC - 046838010606
View all JVC M505 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Connections Speaker layout Front left speaker Center speaker Front right speaker Powered subwoofer Connecting a TV • You can get better picture quality in the order - Component video > S-video > Composite video. • Distortion of picture may occur when connecting to the TV via a VCR, or to a TV with a built-in VCR. • You need to set "MONITOR TYPE" in the PICTURE menu correctly according to the aspect ratio of your TV. (A pg. 39) 7 To connect a TV equipped with the component video input jacks Center unit TV Surround left speaker Surround right speaker NOTE • Although the satellite speakers and the powered subwoofer are magnetically shielded, the TV screen may appear mottled. In this case, keep enough distance between the speakers and the TV. • The speakers are magnetically shielded to avoid color distortions on TVs. However, if not installed properly, they may cause color distortions. So, pay attention to the following when installing the speakers. - When placing the speakers near a TV set, turn off the TV's main power switch or unplug it before installing the speakers. Then wait at least 30 minutes before turning on the TV's main power switch again. Some TVs may still be affected even though you have followed the above. If this happens, move the speakers away from the TV. • Place the satellite speakers on a flat and level surface. • Be sure to place the powered subwoofer to the TV's right. If you place the powered subwoofer to the TV's left, keep sufficient distance between them to prevent the TV screen from appearing mottled. For TH-M606/TH-M603 only: • Do not lean against the satellite speakers, as the speakers could fall down or break, possibly causing injury. Especially be careful not to let children lean against them. To component video input Component video cord (not supplied) NOTE • If your TV supports progressive video input, you can enjoy a high quality picture by setting the progressive scan mode to active. (A pg. 20) • If the component video input jacks of your TV are of the BNC type, use a plug adapter (not supplied) to convert the pin plugs to BNC plugs. • The component video signals can be output only when you select "DVD" as the source to play. (A pg. 19) 7 To connect a TV equipped with the composite or Svideo jacks Center unit Composite video cord (supplied) or S-video cord (not supplied) Align the 5 marks. To S-video input To composite video input TV 14