JVC M505 Instructions - Page 40
Sound and other settings, Press SETTING., Press Cursor, to select the item, you want to set. - th noise
UPC - 046838010606
View all JVC M505 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Advanced operations Sound and other settings IMPORTANT Before using the remote control for the following operation; • Set the remote control mode selector to AUDIO. NOTE Before you start operation; • There is a time limit when doing the following steps. If the setting is cancelled before you finish, start from step 1 again. 1 Press SETTING. Example: BAL : CENTER 2 Press Cursor Y/5 to select the item you want to set. • BAL (Balance): You can adjust the balance between the front left and front right speakers. • DEC (Decode): When you play an external source (DBS is selected as a source) that was encoded with Dolby Digital or DTS Digital Surround, the following symptoms may occur; • No sound comes out at the beginning of playback. • Noise comes out while searching for or skipping chapters or tracks. AUT/PCM (Auto/PCM): Normally select this. The system automatically detects the incoming signals. DOLBY D: Select this if the symptoms above occur when playing a disc (or software) encoded with Dolby Digital. DTS: Select this if the symptoms above occur when playing a disc (or software) encoded with DTS Digital Surround. See page 26 for button locations. • M. OUT (Monitor Out): Select the video output jack type by which you watch DVD playback after connecting your TV. (A pg. 14) Set the video output to use AV COMPU LINK remote control system. (A pg. 44) VIDEO: To watch DVD playback via the VIDEO jack. S: To watch DVD playback via the S-VIDEO jack. COMPNT (component): To watch DVD playback via the COMPONENT VIDEO OUT jacks. • DiscIll (For TH-M606/TH-M603/TH-M505/TH-M501): When you select DVD as the source and leave the system in stop mode for 5 minutes, the disc lamps starts illuminating. 3 Press Cursor 3/2 to make an adjustment or selection. Example: B A L : R -- 5 The adjustment is set and display automatically disappears a few seconds later. NOTE • When "DOLBY D" or "DTS" is selected, if a signal encoded with another digital format comes in, you cannot listen to the sound. (The GDIGITAL or C indicator flashes.) 37