JVC MV40US Instruction Manual - Page 59

Manual Dubbing (From VCR To DVD) Dubbing A Part Of A Cassette You can dub the selected scenes on a tape to the DVD disc, starting and stopping wherever you wish. ● Turn on the unit. ● Turn on the TV and select the video channel (or AV mode). ● Slide the TV/CABLE/DBS/DVD switch to DVD. REC VCR ] VCR/DVD MODE DVD DUBB. DUBB. Lamp 8 3 U 59 7 VCR/DVD 1 2 3 4 5 6 7 8 9 0 3 8 REC MODE 4 5 9 7 NOTES: ● If you set the dubbing direction incorrectly, you could erase an important recording that you wanted to dub. It is recommended to conduct a test with unimportant cassettes first. ● There may be a discrepancy of several seconds between where you intend dubbing to start, and where it actually starts. ● The superimposed indication during the operation or dubbing is not recorded. ● It is not possible to dub a tape with a copy protection signal. ● If the recording capacity of disc become full, the tape stops automatically. ● It is not possible to perform other operations like Live Memory Playback. Check the recorded program on the disc after dubbing. ● Dubbing is not possible on the discs used exclusively for On-Disc Timer Programming. ● When dubbing can not be performed properly, set "BLUE BACK" to "OFF". (੬ pg. 72) EDITING EN 59 1 Press VCR/DVD repeatedly so that the VCR lamp lights up on the unit. 2 Press SET UP to access the Main Menu screen. 3 Press rt to select "COPY SET", then press ENTER. MAIN MENU COPY SET FUNCTION SET 4 Press rt to select "COPY MODE", then press ENTER to select "FULL COPY" or "1 PROG.". ● Pressing ENTER toggles the setting PRESS ( , ) THEN (OK) (SET UP) TO END COPY COPY MODE FULL DISC AUTO FINALIZE FULL COPY OFF OFF between "FULL COPY" and "1 PROG.". 5 Press SET UP to complete the setting. ● When "1 PROG." is selected, recording ( , ) THEN (ENTER) (SET UP) TO END will stop when an index code or unrecorded portion is detected. 6 For VCR deck Load a cassette you want to dub. For DVD deck Load a recordable disc. 7 Press VCR]DVD to select the dubbing direction. 8 Locate the point from where you want to start dubbing, then pause playback by pressing the following buttons: 4, 5, 3, 8, 9 9 Prepare the DVD deck for dubbing. A Press VCR/DVD repeatedly so that the DVD lamp lights up on the unit. B Press REC MODE repeatedly to set the recording mode. C Press 7 and 9 simultaneously so that the DVD deck enters the Record Pause mode. 10 Press and hold DUBB. for more than 2 seconds to start dubbing. The dubbing (DUBB.) lamp lights up on the unit. ● When dubbing a tape-end recorded VHS tape, set the input of this unit to a no signal input channel (L-1, F-1 etc.) before dubbing. If a broadcast channel is selected, broadcast images may be recorded to the end of the dubbing. ● To stop dubbing, press 8. ● Upon completing dubbing, dubbing ends automatically even without pressing 8.