JVC SR-MV30U Instruction Manual - Page 22
Cable Box and/or DBS Receiver Control Setting (DVD Deck Only), Installing Controller
View all JVC SR-MV30U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
22 EN INITIAL SETTINGS Cable Box and/or DBS Receiver Control Setting (DVD Deck Only) The following procedure is required if you receive your TV channels through a cable box (descrambler) and/or if you receive satellite channels through DBS (Direct Broadcast Satellite) receiver. The Controller allows the unit to automatically switch the cable box or DBS receiver's channel during timer recording. NOTES: ● The Controller is effective for "VCR Plus+® Timer Programing" (੬ pg. 41), "Manual Timer Programing" (੬ pg. 42), or "On-Disc Timer Programing" (੬ pg. 43). ● When connecting your cable box, refer to its instruction manual. Installing Controller 1 If both a cable box and a DBS receiver are used, position the Controller so its signal reaches the receiving windows of both the cable box and DBS receiver. 2 Fix securely using the adhesive strip attached on the back of the Controller. Cable box or DBS receiver If your cable box or DBS receiver does not have audio/video output connectors Connect the RF output connector on the cable box or DBS receiver to the VHF/UHF IN (DVD) connector on the rear of your unit via antenna splitter. If your cable box or DBS receiver has audio/video output connectors Connect the audio/video output connectors on the cable box or DBS receiver to the AUDIO/VIDEO INPUT connectors on the rear of the unit. ● If both a cable box and a DBS receiver are used, it is recommended that you connect the DBS receiver to your unit's AUDIO/VIDEO INPUT connectors and the cable box to your unit's VHF/UHF IN (DVD) connector via antenna splitter. 4 Connect the Controller to the CABLE BOX connector on the rear panel. VCR/DVD ENTER SET UP 1 2 3 4 5 6 7 8 9 0 rtw e Your unit Controller (suggested locations) 3 Connect the controller to the unit. a Cable box or DBS receiver To RF output Transmitter Controller To Audio/video output or To VHF/UHF IN (DVD) Your unit To AUDIO/ VIDEO INPUT Setting Brand And Channel After installation, set the cable box or DBS receiver's brand and channel correctly; otherwise, the Controller cannot work correctly. ● Turn on the unit. ● Turn on the TV and select the video channel (or AV mode). ● Slide the TV/CABLE/DBS/DVD switch to DVD. 1 Turn on the cable box or DBS receiver. 2 Press VCR/DVD repeatedly so that the DVD lamp lights up on the unit. 3 Press SET UP to access the Main Menu screen. 4 Press w e to select "INITIAL SET UP", then press ENTER. 5 Press w e to select "STB SET", then press ENTER. 6 Press rt to select "CABLE BOX SET" or "DBS RECEIVER SET", then press ENTER. CABLE BOX 7 Press rt to select "CABLE BOX OUTPUT CH" or "DBS RECEIVER OUTPUT CH", then press ENTER.