JVC SR-TS1U SR-TS1U VCR Instruction Manual (1812KB) - Page 59
Control Two JVC VCRs, Child Lock
View all JVC SR-TS1U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
NUMBER "1" POWER 1 2 3 NUMBER "2" 2 4 5 6 7 8 9 0 TIMER 4 1 STOP 3 A/B EN 59 Control Two JVC VCRs The remote control is capable of controlling two JVC VCRs independently; one set to respond to your remote control's A code control signals and another set to respond to B code control signals. The remote control is preset to send A code signals because your VCR is initially set to respond to A code signals. You can easily modify your VCR to respond to B code signals. UNPLUG VCR'S POWER CORD 1 Unplug from the AC outlet. SET REMOTE CONTROL CODE 2 While holding down A/B on the remote control, press the NUMBER key "2" and then press STOP. PLUG IN POWER CORD 3 Plug back in to the AC outlet. TURN VCR POWER ON 4 Press POWER on the remote. Child Lock This feature allows you to prevent the operation of the VCR. TURN VCR POWER ON 1 Press POWER. ENGAGE CHILD LOCK 2 Press and hold POWER on the remote control until the Child Lock indicator ("-") appears on the front display panel. ● Power turns OFF and the VCR cannot be turned on from the POWER button on the front panel. ● To cancel Child Lock, press and hold POWER on the remote until the VCR turns on. During timer recording, pressing TIMER also cancels Child Lock. NOTES: ● When Child Lock is engaged, make sure to keep the remote control out of the reach of children. ● Timer recording of programs that were previously set can be performed while the Child Lock is engaged. The feature remains in effect after the recording is finished. The VCR will now respond only to B-code commands. To set the VCR back to respond to A code signals, repeat the same procedure as shown above except pressing NUMBER key "1" instead of "2" in step 2. You can control two VCRs with the same remote control by switching the remote's code between A and B (੬ step 2), pressing "1" for A-code commands and "2" for B-code commands. (Ex.) To set remote control B code: MBR SET A/B 2 STOP Release Hold down Press in succession