JVC TS1U SR-TS1U VCR Instruction Manual (1812KB) - Page 35
Make Connections, Turn On All Components, Set Recording Vcr's, Input Mode, Prepare For Recording,
View all JVC TS1U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
EN 35 REC CH STOP/EJECT 5 START RECORDING Press REC on either of SR-TS1U. When the tape reaches to the end while recording, the other SR-TS1U successively starts to record. Therefore, recording will be continued onto cassettes loaded on two SR-TS1U alternately. JOG SHATTLE ● The cassette will automatically be rewound when the recording stops. ● Replace the cassette after rewound if you want to continue to record onto another cassette. STOP PLAYBACK 6 Press STOP/EJECT on the SR-TS1U which is recording. Using two sets of SR-TS1U, a long recording will be possible (such as camcorder recording, another VCR playback or TV broadcast). Use the buttons and controls on the VCR's front display panel for the Series Playback operations (except when using Mode Lock). 1 MAKE CONNECTIONS Connect two sets of SR-TS1U to other equipment, antenna or cable as shown in the illustration on page 34. ● The mini-plug cable is a mono 3.5 mm mini-plug to mono 3.5 mm mini-plug connector. ● When connecting a camcorder or another VCR with an S-VIDEO output connector as recording source, it is recommended to use the S-VIDEO connection to minimize picture degradation. TURN ON ALL COMPONENTS 2 After completing the connections, turn on all the components. ● Set the TV to video input mode or A/V input mode. Refer to the TV instruction manual. SET RECORDING VCR'S INPUT MODE 3 Set to "AUX". Press CH 5∞ to select the input mode depending on the connector being used - "L-1" for the rear AUDIO/VIDEO IN connector, or "F-1" for the front AUDIO/VIDEO IN connector. PREPARE FOR RECORDING 4 Insert the recording cassette into each SR-TS1U, and prepare the playback source. NOTE: If you do not want to display the superimposed indication on the screen during recording, set it to "OFF" (੬ pg. 30). If the playback equipment has a superimpose/OSD disable feature, set its superimpose or display feature to "OFF" as well. To prohibit operations during Series Recording (Mode Lock) Press and hold OK on the remote control for more than 5 seconds. The Mode Lock indicator lights up on the front display panel (੬ pg. 66). The picture will be recorded onto the cassettes alternately without any interruption. To resume the other operations, press and hold OK on the remote control again for more than 5 seconds. NOTES: ● Series Recording is also possible using the front AUDIO/ VIDEO connectors. ● When recording a TV broadcast, tune in the same channel on both SR-TS1U. ● If you do not want to record the superimposed operational indications on the screen during Series Recording, set the Superimpose mode both in playback and recording to "OFF". (੬ pg. 30)