JVC TS1U SR-TS1U VCR Instruction Manual (1812KB) - Page 7

Connect the power plug to an AC outlet before installing the lithium battery. (See below) Antenna or Cable Flat Feeder EN 7 AC Power Back of VCR Cord Coaxial Cable To ANTENNA IN CABLE BOX S VIDEO IN OUT IN OUT R AUDIO L (MONO) VIDEO REMOTE ANTENNA IN CH3 CH4 VHF/UHF TV OUT Matching Transformer (not supplied) To AC Outlet To S VIDEO OUT To S Video Input Connector S-Video Cable (supplied) To AUDIO/ VIDEO OUT To TV OUT Audio/Video Cable (supplied) RF Cable (supplied) To Audio/Video Input To Antenna Input TV NOTES: ● To make the most of the Super VHS picture performance we recommend that you use the supplied S-VIDEO cable to connect your VCR to a TV with an S-VIDEO input connector. ● To operate the VCR with your TV using the S-VIDEO connection, set your TV to the AV mode using the TV's remote control. You can also use the TV/VCR button on the VCR's remote control to set your TV to the AV mode. (੬ pg. 56) S-VIDEO Connection CONNECT VCR TO TV a- Connect both the RF cable and the AV cables to the TV as explained in step 3 of "Basic Connections" (੬ pg. 6). b- Connect the S-Video cable between the S-VIDEO OUT jack on the rear of the VCR and the S-Video Input on the TV. Be sure to connect the power plug to an AC outlet first before installing the lithium battery; otherwise, the battery's service life will be drastically shortened. Installing/Removing the lithium battery 1 Make sure that the power plug is connected to an AC outlet and turn off the VCR. 2 Open the battery cover while pressing the release tab as illustrated. 3 Insert a lithium battery with the plus (+) side up and push it in. ● To remove the lithium battery, press the latch A downward using a pointed non-metallic object, then pull out the lithium battery. 4 Close the battery cover until it clicks in place. A