JVC VN-C2U Instruction Manual - Page 27
image is in focus.
 |
View all JVC VN-C2U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
The image is out of focus. The focus can be adjusted by following the procedure given below. 1.Set the pan and tilt positions to 0˚,0˚. 2.Remove the lens cover. 3.Loosen the screw locking the lens block. Note:For your safety, turn off the power before loosening the screw. 4.Start up the VN-C2U controller so that the VN-C2U image can be viewed. 5.Rotate the lens block slowly until the image is in focus. 6.Securely tighten the lock screw. 7.Close the lens cover (check to make sure that the notches on the lens cover and case are aligned). Lens block Mount so that the notches are aligned Lens cover Lock screw 22
-
1 -
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22 -
23 -
24 -
25 -
26 -
27 -
28 -
29 -
30
 |
 |
22
The image is out of focus.
The focus can be adjusted by following the
procedure given below.
1.Set the pan and tilt positions to 0˚,0˚.
2.Remove the lens cover.
3.Loosen the screw locking the lens
block.
Note:For your safety, turn off the power
before loosening the screw.
4.Start up the VN-C2U controller so that
the VN-C2U image can be viewed.
5.Rotate the lens block slowly until the
image is in focus.
6.Securely tighten the lock screw.
7.Close the lens cover (check to make
sure that the notches on the lens cov-
er and case are aligned).
Lens block
Lens cover
Lock screw
Mount so that the notches
are aligned