JVC VN-X235U Instruction Manual - Page 8

Getting Started Name and Function of Parts (continued) Lens Y Q X R S U T W U V T Q Tilt fastening screw Note: ● After adjusting the field angle, tighten the tilt fastening screw to secure the camera so that its field angle does not go out of alignment. (A [READ ME FIRST]) R Focus adjustment ring Move the ring to the left and right to adjust the focus. (A [READ ME FIRST]) S Zoom adjustment ring Move the ring to the left and right to adjust the field angle. (A [READ ME FIRST]) T [MONITOR] terminal (pin jack) (A [READ ME FIRST]) U [RESET] button This button has two functions as described below, depending how it is being pressed. ● Reset function (press for less than 2 seconds and release) Reboots the camera. Reboot takes about 1 minute. During this interval, the [RESET] button is disabled. ● Focus adjust function (press for at least 2 seconds and release in less than 5 seconds) The camera enters the focus adjust mode and the status indicator V blinks in green and orange alternately. This function can also be used on the viewer. Refer to [INSTRUCTIONS (Setting)]. Note: ● During the focus adjust mode, the screen may flicker when the electronic shutter is operating. This is not a malfunction. ● Pressing this button for 5 seconds or longer switches the camera to the Service Check mode. The status indicator lights up in orange color in this mode. Do not press the button for 5 seconds or longer. ● To make use of the focus adjust function of the Reset button, restart the camera after setting the [MONITOR OUT] output selection switch W to ANB or APB. 8