Jenn-Air JFFCC72EF Instruction Sheet - Page 1
Jenn-Air JFFCC72EF Manual
View all Jenn-Air JFFCC72EF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Installation Instructions for Pressure Regulator on Customer Supply Line On Models: JFFCC72EFS04, JFFCC72EHL02, KRFC604FSS03, KRFC704FBS03, KRFC704FPS04, KRFC704FSS03, WRF954CIHM02, WRF954CIHB02, WRF954CIHW02, WRF954CIHV02, WRF954CIHZ03 IMPORTANT: ■ Pressure regulator kit intended for use on the above models to assist in the dispensing of water in households with high water pressure. ■ Connect the pressure regulator to your water supply line in accordance with all state and local codes and ordinances. ■ Make sure to turn off water supply before installation. A B product. Disconnect the supply line from the household side, using the container to catch the draining water. Do not disconnect from the product. INSTALLING THE PRESSURE REGULATOR 1. Use the provided 24" (61cm) long PEX water line. 2. Using the tube cutter or utility knife, cut the household supply line at the measurement. Ensure that tubing is cut square with no burrs, sharp edges, or deformation to prevent leaking. 3. For bottom mount and side-by-side platforms, locate and remove one of the center screws holding the machine compartment cover in place. (If not available, locate a similar location on the product.) See Figure 2. C D D Figure 1 Kit Contains: A. (1) Pressure Regulator B. (1) Mounting Clip C. (1) Screw D. (2) Adhesive-backed Tubing Clip E. (1) Installation Instruction (not pictured) F. (1) Waterline-valve-regulator (not pictured) NOTE: Attaching the pressure regulator will require a 2" spacing from back of appliance to the wall. This may be greater than before installation, causing the appliance to stick out further. Tools Needed: ■ PEX Tube Cutter -OR- Utility Knife ■ Phillips Screwdriver ■ Small container for draining the hose ■ Copper Tubing Cutter (If copper water line) WARNING Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. PREPARING THE APPLIANCE FOR SERVICE 1. Unplug appliance or disconnect power. 2. Turn the water off at the household supply. 3. If servicing a refrigerator, purge the product by dispensing water for at least 30 seconds. 4. Locate the line connecting the household supply to the W11502228A EXAMPLE OF MOUNTING CLIP LOCATION Figure 2 4. Using the existing hole, attach the mounting clip with the provided screw. Tighten screw so that the clip does not freely rotate. See Figure 3. MOUNTING CLIP ATTACHED WITH SCREW Figure 3 5. Connect the pressure regulator in between the loose ends of the water line by pressing the line ends firmly into the pressure regulator's connectors. See Figure 4. IMPORTANT: Ensure that the water flow direction indicator arrow on the pressure regulator is pointing in the direction of the water flow (towards the appliance). Verify that the connection is properly made by gently attempting to pull the line straight out. If the line remains connected, the connection was properly made. CONNECTING PRESSURE REGULATOR FROM SUPPLY TO APPLIANCE WATER FLOW DIRECTION INDICATOR ARROW Figure 4