Jenn-Air JFFCC72EF Instruction Sheet - Page 2

6. Attach the pressure regulator to the mounting clip in the orientation shown (Vertical: Outlet on bottom / Inlet on top) See Figure 5. RECONNECTING THE APPLIANCE 1. Reconnect the water supply connections as specified by the product installation instructions, supplied with the product. 2. Turn on the household water supply. WARNING CONNECTION FROM HOUSE HOLD WATER MOUNTING CLIP Figure 5 7. If necessary, add the two adhesive-backed tubing clips on the household supply line to support the line and prevent kinking. See Figure 6. ADHESIVE TUBING CLIPS Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 3. Reconnect power to the product. 4. Ensure the product is turned on and cooling. 5. If servicing a refrigerator, purge the product by running the water for at least one minute. NOTE: If there is no water, check that the pressure regulator was installed in the proper flow direction. IMPORTANT: Check all connections for leaks. When placing the product into its final location for usage be sure not to kink the household supply line. A kinked supply line could cause no ice or water, or low ice and water problems. Leave a two inch (2") minimum gap between the appliance back and wall. Figure 6